To evaluate the specificity of the sign for KD diagnosis, patients aged 2
years or younger who were diagnosed as having respiratory syncytial virus or rotavirus infection using a commercial rapid test and who required hospitalization were observed.
Results: Of the 15,524 KD patients with a history of BCG vaccination, 7745 (49.9%) had redness or crust formation at the BCG inoculation site. This was observed in more than 70% of complete KD patients aged 3 to 20 months. Of these patients, the proportion with this sign in the group whose first day of hospital visit was within 1 to 4 days from the onset was significantly larger than that of the other patients groups (5-9 or 10 + days) (52.1%, Selleck PD-L1 inhibitor P < 0.001). Among the patients with respiratory syncytial virus or rotavirus infection, none showed these changes at BCG inoculation site.
Conclusions: Redness or crust formation at the BCG inoculation site is a useful diagnostic sign for KD GSK2126458 supplier among children aged 3 to 20 months in countries with a BCG vaccination program. Even if patients have 4 or fewer signs of the clinical criteria for KD, physicians should consider that patients with redness or crust formation at the BCG inoculation site could suffer
from KD.”
“Silicone rubber films with graded and localized mechanical properties are prepared using two-part polydimethylsiloxane (PDMS) elastomer, photoinhibitor compounds and conventional photolithography. First the un-cross-linked PDMS is mixed with benzophenone. The resulting positive photosensitive material is then exposed
through a mask to UV light from a conventional mask aligner. Cross-linking of the UV exposed elastomer is inhibited, leading to softer regions than the surrounding unexposed matrix. By empirically fitting the nonlinear, hyperelastic Mooney-Rivlin model to experimentally measured stress-strain curves we determine the equivalent tensile modulus (E) of the rubber see more film. We show the PDMS tensile modulus can then be adjusted in the 0.65-2.9 MPa range by decreasing the UV exposure dose (from 24 000 to 0 mJ cm(-2)). Further, using a patterned UV mask, we can locally define differential regions of tensile modulus within a single PDMS rubber film. We demonstrate that “”hard islands”" (E approximate to 2.9 MPa) of 100 mu m minimum diameter can be patterned within a 100-mu m-thick, single “”soft”" PDMS rubber membrane (E approximate to 0.65 MPa) cured at 150 degrees C for 24 h. Thin gold film conductors patterned directly onto the photopatterned PDMS are stretchable and withstand uniaxial cycling to tens of percent strain. The mechanically “”pixellated”" PDMS rubber film provides an improved substrate with built-in strain relief for stretchable electronics. (C)2011 American Institute of Physics. [doi:10.1063/1.