The productions of different ROS species, such as O2  ·−, H2O2, and OH·, were also studied. Furthermore, a systematic comparison of the intracellular parameters with N-TiO2 and TiO2 nanoparticles as www.selleckchem.com/products/azd8186.html photosensitizers for PDT was investigated. The changes of mitochondrial membrane potential (MMP), intracellular Ca2+, and nitrogen monoxide (NO) concentrations with time after the PDT were measured. The relationships

between these parameters were discussed. The morphological changes of cytoskeletons after irradiation were also examined by a confocal microscope at different times after the PDT. The killing effects between pure and nitrogen-doped TiO2 were compared. Methods Preparation and characterization of N-TiO2 samples The details of preparation of N-TiO2 nanoparticles were described MLN8237 in our previous paper [10]. Briefly, The anatase TiO2 nanoparticles (particle size <25 nm; Sigma-Aldrich, St. Louis, MO, USA) were calcined at a flow rate of 3.5 L/min in ammonia atmosphere

at 550°C for 20 min to produce the N-TiO2 nanoparticles. The crystalline phases of the N-TiO2 nanoparticles were determined OICR-9429 by Raman spectra to be anatase. The ultraviolet-visible (UV/Vis) diffuse reflectance absorption spectra (Additional file 1: Figure S1) of the N-TiO2 and TiO2 samples were measured with a Jasco V550 UV/Vis spectrophotometer (Jasco, Inc., Tokyo, Japan). Pure and N-doped TiO2 nanoparticles were autoclaved and dispersed in DMEM-H medium at a concentration of 100 μg/ml, respectively. The samples were ultrasonicated for 15 min before using. Cell culture and PDT treatment The human cervical carcinoma cells (HeLa) procured from the Cell Bank of Shanghai Science Academy were grown in Petri dishes in DMEM-H solution supplemented with 10% fetal calf serum in a fully humidified incubator at 37°C with 5% CO2 Urease for 24 h. The cells were incubated with 100 μg/ml pure or N-doped TiO2 under light-free conditions for 2 h and were then illuminated with a visible light filtered by a bandpass filter (400 to 440 nm) from a Xe lamp (100-W; Olympus, Center Valley, PA, USA) at a power density of 40 mW/cm2 for 5 min.

The transmission spectrum of that bandpass filter was shown in Additional file 2: Figure S2. As shown in the figure, the filter could transmit some light with the wavelength below 400 nm. Therefore, the pure TiO2 could still absorb a small amount of the transmitted light. Measurement of ROS induced by TiO2 or N-TiO2 in aqueous suspensions For the measurement of photo-induced ROS in TiO2 or N-TiO2 aqueous suspensions, 2′,7′-dichlorfluorescein (DCFH), was used as a probe. The DCFH was converted from the diacetate form DCFH (DCFH-DA) (Sigma-Aldrich) by adding 0.5 ml of 1 mM DCFH-DA in methanol into 2 ml of 0.01 N NaOH and keeping the mixture at room temperature in the dark for 30 min. It was then neutralized with 10 ml sodium phosphate buffer (pH = 7.2) [21].