8 Cells were grown in 100-mL shake cultures in a shaking water b

8. Cells were grown in 100-mL shake cultures in a shaking water bath (Shaker GFL, Burgwedel, Germany) at 200 r.p.m. in a methane–air–CO2 (9 : 9 : 2) atmosphere. Compounds were added to exponentially growing cells. Cultures were incubated in the presence of different organic solvents for 3 h. Cells were then harvested, washed twice with potassium phosphate buffer (50 mM, pH 7.0)

and stored at −20 °C before use. The toxicity of the organic compounds was quantified by the effective concentration 50% (EC50), i.e. the concentration that causes a 50% inhibition Selleckchem KPT-330 of bacterial growth as described earlier by Heipieper et al. (1995). Growth inhibition caused by the toxic compounds was measured by comparing the differences in the growth rate μ (h−1) between intoxicated cultures (μtoxin) with that of control cultures

(μcontrol). The growth inhibition of different concentrations of the organic compounds was defined as the percentage of the growth rates of intoxicated cultures and that of control cultures without toxin addition. The lipids were extracted with chloroform/methanol/water as described by Bligh & Dyer (1959). Fatty acid methyl esters (FAME) were prepared by incubation for 15 min at 95 °C in boron trifluoride/methanol applying the method of Morrison & Smith (1964). FAME were extracted with hexane. Analysis of FAME in hexane was performed using a quadruple http://www.selleckchem.com/products/gsk2126458.html GC System (HP5890, Hewlett & Packard, Palo Alto, CA) equipped with a split/splitless injector and a FID. A CP-Sil

88 capillary column (Chrompack, Middelburg, the Netherlands; length, 50 m; inner diameter, 0.25 mm; 0.25 μm film) was used for the separation of the FAME. GC conditions were: injector temperature was held at 240 °C and detector temperature was held at 270 °C. The injection was splitless, and the carrier gas was He at a flow of 2 mL min−1. The temperature program was: 40 °C, 2-min isothermal; 8 °C min−1 to 220 °C; and 15-min isothermal at 220 °C. The peak areas of the FAMEs were used to determine their relative amounts. The fatty acids were identified by GC and co-injection of authentic reference compounds obtained from Supelco (Bellefonte, PA). The degree of saturation of the membrane fatty acids was defined as the ratio between the saturated fatty acid (C16:0) and the unsaturated fatty acids (C16:1Δ9trans, C16:1Δ9cis, C16:1Δ10cis, C16:1Δ11cis) present in Y27632 these bacteria (Guckert et al., 1991). The genomic DNA of the tested stains was isolated using the DNeasy Tissue Kit (Qiagen, Hilden, Germany) following the manufacturer’s instructions. From the amino acid sequences, primer sets were designed from the cti consensus sequences from Pseudomonas fluorescens Pf-5 [YP_260763]; P. fluorescens PfO-1 [YP_348835]; Pseudomonas psychrophila [BAB41104]; Pseudomonas putida KT2440 [NP_744525]; Pseudomonas syringae pv. phaseolicola 1448A [YP_274814]; P. syringae pv. tomato str. DC3000 [NP_792539]); and M. capsulatus Bath (YP_114244).

Comments are closed.